Belt Strap Buckles for Mens Ratchet Belts Replacement

Swap your hardware with this gunmetal ratchet buckle, built from solid zinc to grip 1 3/8 inch leather straps without slipping.

$14.99In stock4.6 from 105 ratings

Strap width: 1 3/8″
Colourway: Gun
Fastening: Ratchet track
Length: Cut down at home

What this one is

A spare buckle changes the look of your strap in seconds. We cast this one from solid zinc with a scratch-resistant gunmetal coating, sizing the frame for 1 3/8 inch ratchet leather. An extended release lever sits naturally under your finger, letting you make micro-adjustments with one hand throughout the day.

How it is put together

Single Piece Latch

We simplified the internal latch into a single solid piece. It locks directly onto the track teeth under the strap, holding your waistband steady and resisting up to sixty pounds of pulling force.

One Hand Release

We lengthened the release lever and repositioned it along the bottom edge. Your finger finds it without fumbling, so you can loosen or tighten your belt in quarter inch steps with one hand.

Solid Zinc Casting

We cast the body from pure zinc and finish it in gunmetal with a hard protective coat. The smooth surface resists scratches and daily wear while sliding easily through standard belt loops.

Tool Free Assembly

The hinged clamp on the back opens wide to accept any 1 3/8 inch ratchet strap. Trim your leather to length at home, push the raw end into the housing, and clamp the teeth down.